While back someone asked for hose lengths. It happens I saved my old ones when I had them replaced when the HU was replaced. I intended to get stainless ones made sometime, haven't done it yet. I do not believe this information will be useful without a set for your hosemaker guy to match the ends to. If someone gets serious about this I can probably photograph each hose & each end (3/hose) with appropriate scale included. If someone wants to get REALLY serious & line up someone who would make sets available to anyone on the list I would contribute mine as patterns. These lengths are banjo center to banjo center OR end of thread to end of thread OR end of thread to banjo center. The angle was estimated, not measured. 12 1/8" springwound one end straight Banjo, one end 30 degree angled Banjo 10 1/4" Straight femail thread both ends, two rubber grommets 9" one end 30 degree angled Banjo, one end straight female threads 22 3/4" one end striaght female threads, one end straight Banjo, 2 grommets, 1/2 spring wound 36" One end straight female threads, one end 30 degree angled banjo, 4 grommets, spring wound 5 3/8" one end straight female thread, one end long curved Banjo 26 3/8" both ends have long, curved Banjos - Not the same shape 6" one end straight female thread, one end long curved Banjo For any of you contemplating this, the service tech that replaced mine told me "If you ever want this done again, take it someplace else." Not his idea of a fun job. Bill
