In a message dated 6/23/01 5:44:29 PM Eastern Daylight Time,
[EMAIL PROTECTED] writes:
<< >If it stays on......simply flip the kill switch to off, turn
>on the key, and hit the start button 10 times. It resets it >and turns the
light off.
As far as i know this is only possible in dealer mode .
Normally just turning the ignition off and then back on resets
it . >>
If the ABS warning light on the dash is flashing, turning the key off then on
will stop the flashing as long as a fault is no longer detected. If it is
remaining on steady...... then as long as the fault exists, it will stay on.
The hitting the start button ten times in two seconds will clear the memory
in the ABS ECU. It has nothing to do with turning the light off. If it is on
steady, something is wrong and ABS is not functioning. Conventional breaking
should be, just no ABS. The only way to get a steady ABS waring light to go
out is to correct the fault. Retrieving the code from the ECU will point you
in the direction you need to look to find the cause of the fault.
RSRBOB
