Hi. Reclassed controls are stored in the .we file for the application.
If it causes you problems you can open the folder where your sets are
contained and remove the .we file which was created. If you are not sure
which .we file to remove, simply sort the files in the folder by
modified date. I'm assuming you did this recently, and so if you did
then the .we file should be easy to find.
Angelo Ercolamento said the following on 7/23/2008 3:07 PM:
hi I tried to change the custom control on a program, but now my num
pad stopped working, and I can't seem to change it back, I remember this
happening before but just don't remember the fix.
thanks for your help in advance
Angelo
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
--
Raul A. Gallegos -- GW Micro Technical Support
Voice: 260-489-3671 -- Fax: 260-489-2608
WEB: http://www.gwmicro.com
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
