Buttons if they are actual controls can be done with control-insert-f.
The information is stored in a .we file associated with the program.
Graphics are done differently. It's best to save a set file, open a
blank graphic dictionary and save it so that your graphic definitions go
into the graphic dictionary for that set only. Place the mouse pointer
on the graphic and press control-shift-e and type in your description.
When you are done, remember to save your graphic dictionary. Sections
7.2, 7.3, 10.7, and 16.6 will give you the necessary information on what
you might need to know. I'm not sure how much you know about creating
set files, so some of these sections may not be needed.
Hope this helps.
CHAD BAKER said the following on 8/15/2008 10:38 AM:
Hi is there a way to label buttons and graphics?
I'm using a application that has a lot of buttons and graphics not sure
if its possible never done it before.
Thanks
Chad Baker
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
--
Raul A. Gallegos -- GW Micro Technical Support
Voice: 260-489-3671 -- Fax: 260-489-2608
WEB: http://www.gwmicro.com
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
