Chris Belle wrote:
But the spots aren't being created in the files.
Which files are you referring to?
What's happening is that the wizard is going but often the save button
isn't showing up.
You mean it isn't there at all?
Sometimes I get a close button instead of a save button.
When does this happen?
My options for applies to were sonarpdr, global or sfz.
That doesn't make sense, since there are only two radio buttons. Where
are you finding three possible options?
Anyway, it put the stuff for the load hot-key I tried to create in the
sfz section.
What sfz the active window when you pressed Control-Alt-P?
Also, I got several errors which you should have gotten atleast one by now.
One is all I have. I'll investigate.
Aaron
--
To insure that you receive proper support, please include all past
correspondence (where applicable), and any relevant information
pertinent to your situation when submitting a problem report to the GW
Micro Technical Support Team.
Aaron Smith
GW Micro
Phone: 260/489-3671
Fax: 260/489-2608
WWW: http://www.gwmicro.com
FTP: ftp://ftp.gwmicro.com
Technical Support & Web Development
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
