I am finally starting to learn about scripts and have tried to adjust the
output of the progress bars to better suit me and be much less annoying. I
chose seconds intervals of 10, ascending sound, and not to speak text. I
saved the changes. By the way, this is the latest update of this script as
of just a few minutes ago.
Before I updated this script, I heard a tiny tick tick sound every 10
seconds. Eventually it got to a low enough tone that I heard it but at a
very low volume, and I do not have a hearing problem. After updating the
script, I don't even hear the ticks and the sound never becomes audible.
What am I missing here? Is there a way that I can make it louder or start
at a higher tone? Is there a problem with ascending tones that make them
inaudible? When I changed it to default sound, I got a water drop falling
sound every 10 seconds which was fine except that I'd like the ascending
pitch to indicate how close to done the task is.
Is there a way to make a louder or different sound when it reaches 100
percent? It would be nice to have it give a soft tone ascending to the top
and a louder kind of ta-da sound to indicate it's finished. Is this possible?
Thanks!
Marilyn
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[email protected] and include leave gw-info in the body
of the message.
