Doug, Steve, That was it thank you!! I did follow the article directions and poof they came back ! I am now going to play and see if the Eloquence is still pausing while in a read to end in IE and if so I will call Doug and let him hear it. Maybe since I turned them off and then back on the patch will have worked it's magic on the pausing problem. Thanks again for the pointers.
Shannon ----- Original Message ----- From: Doug Geoffray To: shannon Cc: [email protected] Sent: Monday, February 08, 2010 8:31 AM Subject: Re: Solution to Eloquence voices not found Shannon, The SAPI and ECI versions of Eloquence do not co-exist. It is because you have the older SAPI version that you are not seeing your ECI engines. See our knowledge base article on this when we released WE 7.0 with the ECI version. http://www.gwmicro.com/Support/Knowledge_Base/?kbnumber=GWKB1088 Regards, Doug shannon wrote: Marvin, I had installed the patch and didn't notice any real change but then I changed back to the SAPI eloquence and stopped my pausing problems. Doug had written to me asking if I could call him and demonstrate the pausing problem during a read to end. He said that the patch was to have addressed that particular problem. I was going to switch back to the Eloquence voice and call him this morning but my Eloquence voices are gone. I am not running the script you are talking about and in fact turned off any that I did have running and they didn't come back. Do you have any other ideas as to where they might have gone? I had them last week and now I don't. Shrug Maybe if I get them back the pause problem will have also gone away too. Smile Can't imagine where they went? Thanks for any thoughts Shannon ----- Original Message ----- From: Marvin Commerford To: [email protected] Sent: Saturday, February 06, 2010 12:06 PM Subject: Solution to Eloquence voices not found Good morning. I remember messages about the Eloquence voices not being found after patch installation. I ran into this earlier this morning on my old XP box. The voice rotor script was installed on this machine with Eloquence Reed in the list. Voice rotor didn't find the voice. I checked the synth list in WE and there were no voices listed under Eloquence. I stopped the voice rotor script and like magic the list of Eloquence voices returned to WE's synthesizer list. I restarted the script and again the problem occurred. I tried to remove Reed from its list and put it bak in. It's a no go on this box. The Voice rotor script is the newest version. I may try to remove it and reinstall it from scratch but it seems that this script just does not like something with this particular machine. In summary, you have the Eloquence voices when you install the patch. If you don't see them stop or remove Voice rotor and you'll see them. Good luck. If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv. If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv. If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv.
