You can also reboot the computer and have a lot more time to hold down
the left shift key in order to load the backup synth.
Hth,
Tom
On 9/10/2014 11:49 AM, Marvin Commerford wrote:
Hi. There are a couple of ways to do this. I think the easiest way to
run the backup synth is to bring up the control panel with
ctrl-backslash. Press alt-h, press s and press enter. This runs the
backup synth. If you close WE out you can press andhold the left shift
key immediately after using ctrl-alt-w to start WE. This is tricky
because WE starts very quickly with the newer fast machines. Good luck.
On 9/10/2014 9:58 AM, Casey wrote:
Hi I have A small problem with my window eyes this morning.
That is when my computer starts and window-eyes loads the synthesizer
that is set to load when window-eyes starts causes it to not work.
So I have to use NVDA so how can you correct this?
I would like to be able to change the speech that window-eyes is using
but if I get the err that I am getting cause the voice that I have
selected for window-eyes to use gives it an err at start up.
Then how do I go about changing that voice so the next time I load
window eyes it will use A different voice?
If you reply to this message it will be delivered to the original sender
only. If your reply would benefit others on the list and your message is
related to GW Micro, then please consider sending your message to
[email protected] so the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can
manage your list subscription at http://www.gwmicro.com/listserv.
If you reply to this message it will be delivered to the original sender only.
If your reply would benefit others on the list and your message is related to
GW Micro, then please consider sending your message to [email protected] so
the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage
your list subscription at http://www.gwmicro.com/listserv.
