Hi Casey, Here's a knowledge base article to help you:
http://www.gwmicro.com/Support/Knowledge_Base/?kbnumber=GWKB2012 hth, Rod -----Original Message----- From: Casey [mailto:[email protected]] Sent: Wednesday, September 10, 2014 10:58 AM To: [email protected] Subject: getting window-eyes to run a different sinthasizer if one isn't workin g at start up Hi I have A small problem with my window eyes this morning. That is when my computer starts and window-eyes loads the synthesizer that is set to load when window-eyes starts causes it to not work. So I have to use NVDA so how can you correct this? I would like to be able to change the speech that window-eyes is using but if I get the err that I am getting cause the voice that I have selected for window-eyes to use gives it an err at start up. Then how do I go about changing that voice so the next time I load window eyes it will use A different voice? -- Casey If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv. If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv.
