Don: Actually, much the same occurred with the BL-20. In order to ignore the line breaks and still have a display that made sense, i.e., broke at words, you'd still have to do a fair amount of analysis on the text as it was displayed. Not impossible but I dare say the good folks at HIMS didn't think of it.
On the other hand, isn't there a "compressed reading mode"? Seems to me I recall one. Mike ----- Original Message ----- From: "don bishop" <[email protected]> To: <[email protected]> Sent: Monday, September 28, 2009 8:45 PM Subject: [GWN] line breaks when reading .brf files Hi all, Sure been quiet around here lately. I'm reading a .brf file from bookshare on by braillesense plus. It is reading just fine except that every other line has 32 characters of braille and the other lines have 8 or so. Obviously it's an issue with the line length within the .brf file and the sense is splitting it with 32 characters on one braille line of the display with the remaining characters of the line on the next display. Is there any way to turn off the line break in the .brf file so the sense won't see these? I don't see any such setting in the bs command list, but I could be missing something too. It's certainly not impossible to read this way, but it really would be easier if each display line was filled. Thanks, Don
