I'm kind of thinking this may have been brought up before; however, since I mostly use just the VS without the Sync Braille connected, I can't seem to remember now But, what with having the OnHand now as well, I'm kind of comparing and looking at both my units a bit. Actually, grin, seeing as the OnHand is still kind of new for me and I guess I'm kind of taking it slow with the unit and trying to be extra careful, so I tend to try some of these things on my Voice Sense and Sync Braille first.
Anyway, I was trying to figure out the best way, or perhaps I should say the fastest way, to read email when using the Braille display. So, in doing that, I set the message display time to ignore. And, sure enough, that did stop a lot of the extra messages and thus make the reading of the email much faster. But, after I disconnected the Sync Braille from my VS, I couldn't figure out a way to get my messages to speak again, meaning the voicing of when Bluetooth or WiFi was turned on or off, or to which view and input grade to which I was switching the unit, for examples. Now, I have my option settings backed up, so could easily fix things back; but, were I to not have those backed up and then leave the house without my Sync Braille and before changing the setting from ignore to three, is there any way, short of a hard reset, to get those messages back without having to connect the Sync Braille? If you wish to unsubscribe from this list, visit: http://www.gwmicro.com/listserv
