Don't think so. Mike
[sent via iPhone] On Oct 21, 2010, at 10:28, Vicky Collins <[email protected]> wrote: > I'm kind of thinking this may have been brought up before; however, since I > mostly use just the VS without the Sync Braille connected, I can't seem to > remember now But, what with having the OnHand now as well, I'm kind of > comparing and looking at both my units a bit. Actually, grin, seeing as the > OnHand is still kind of new for me and I guess I'm kind of taking it slow > with the unit and trying to be extra careful, so I tend to try some of these > things on my Voice Sense and Sync Braille first. > > Anyway, I was trying to figure out the best way, or perhaps I should say the > fastest way, to read email when using the Braille display. So, in doing > that, I set the message display time to ignore. And, sure enough, that did > stop a lot of the extra messages and thus make the reading of the email much > faster. > > But, after I disconnected the Sync Braille from my VS, I couldn't figure out > a way to get my messages to speak again, meaning the voicing of when > Bluetooth or WiFi was turned on or off, or to which view and input grade to > which I was switching the unit, for examples. Now, I have my option settings > backed up, so could easily fix things back; but, were I to not have those > backed up and then leave the house without my Sync Braille and before > changing the setting from ignore to three, is there any way, short of a hard > reset, to get those messages back without having to connect the Sync Braille? > > If you wish to unsubscribe from this list, visit: > > http://www.gwmicro.com/listserv > If you wish to unsubscribe from this list, visit: http://www.gwmicro.com/listserv
