Thanks for the input. Could you try the just removed
method with readded $(COMSPEC) /C? Maybe the logic was
good (after all it even works in MS-DOS), just this bit
was causing freeze.

Brgds,
Viktor

On 2009.08.16., at 0:37, maurilio longo wrote:

Viktor,

without the comspec trick a make install freezes, the shell cannot even be killed anymore :(

Best regards.

Maurilio.

PS. See also my other answer to your previous message.


BTW it would be also nice to hear what was the problem
with previous commit (which was working for David), I've
copied the DOS shell method, where the command line limit
is even more restricted, yet it works fine. Maybe it'd be
enough to use GNU cp (like with DOS) for OS/2 too, since
that was also part of the DOS solution, but I didn't commit
that part for OS/2.

I'd welcome your comments and tests, I'm sure there is a
better solution than current one.

Brgds,
Viktor

On 2009.08.15., at 11:40, [email protected] wrote:

Revision: 12125
        
http://harbour-project.svn.sourceforge.net/harbour-project/?rev=12125&view=rev
Author:   mauriliolongo
Date:     2009-08-15 21:40:10 +0000 (Sat, 15 Aug 2009)

Log Message:
-----------
2009-08-15 23:37 UTC+0200 Maurilio Longo ([email protected])
 ! ChangeLog
   ! fixed typo in last commit.

Modified Paths:
--------------
  trunk/harbour/ChangeLog


This was sent by the SourceForge.net collaborative development
platform, the world's largest Open Source development site.
_______________________________________________
Harbour mailing list
[email protected]
http://lists.harbour-project.org/mailman/listinfo/harbour

_______________________________________________
Harbour mailing list
[email protected]
http://lists.harbour-project.org/mailman/listinfo/harbour


_______________________________________________
Harbour mailing list
[email protected]
http://lists.harbour-project.org/mailman/listinfo/harbour

_______________________________________________
Harbour mailing list
[email protected]
http://lists.harbour-project.org/mailman/listinfo/harbour

Reply via email to