Re: [H] Hooking up front USB

[warpmedia]

You can check continuity between the mobo GND pins with a multimeter, 
likely they are common ground (ie same thing) hence pairing should not 
matter.

Thane Sherrington wrote:
I'm hooking up front USB to a motherboard and have run into a problem.
The motherboard connector is standard (I believe.)
+5    +5
D2-    D3-
D2+    D3+
Gnd    Gnd
Key    NC
The cable is broken into four cable sets:
1Power
1D-
1D+
2Power
2D-
2D+
and two grounds.
I assume that 1Power/1D-/1D+ goes on the D2 side and the 2Power/2D-/2D+ 
goes on the D3 side, but I can't tell if the grounds are associated with 
a specific cable set.  Does it matter which ground I put on which side?  
If so, how do I figure out which is which?