I meant for removing the foam dust that clings to everything after the
initial cuts. That will totally defeat any adhesive.
On Aug 23, 2011, at 7:09 AM, Steve Upstill wrote:
In my experience, water is v. poor at removing Playa dust, unless it
has vinegar in it. Perhaps a workbench brush?
--
Them that's got shall get
Them that's not shall lose
So the Bible said and it still is news
-- Billie Holiday, God Bless the Child
On Aug 22, 2011, at 10:31 PM, Phil Dirt wrote:
You can clean the surface with paint thinner and a rag. Or just hose
the dust off the night before taping. No tape will stick properly
when
the surface is covered with dust.
On Aug 22, 2:39 pm, Pichard Kempo Karate <[email protected]>
wrote:
Hi everyone,
so a while back someone suggested to use gorilla tape in addition of
the dual filament tape.
Well using gorilla tape requires to clean up the surface with
rubbing
alcohol and THEN it does not even stick properly.
The morale of the story is... stick to dual filament tape because
you'll save time and money on the long run.
:-) almost happy camper, few days to the playa :D
-- fabien
--
You received this message because you are subscribed to the Google
Groups "hexayurt" group.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to [email protected]
.
For more options, visit this group at http://groups.google.com/group/hexayurt?hl=en
.
--
You received this message because you are subscribed to the Google
Groups "hexayurt" group.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to [email protected]
.
For more options, visit this group at http://groups.google.com/group/hexayurt?hl=en
.
--
You received this message because you are subscribed to the Google Groups
"hexayurt" group.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to
[email protected].
For more options, visit this group at
http://groups.google.com/group/hexayurt?hl=en.
