After reading this again, i see where Peter was going with this. You should have your network card setup with a static IP.
On Tue, Jun 15, 2010 at 2:01 PM, Peter Lindblom <[email protected]> wrote: > Hi ! > > Try "ifconfig -a" and check how your eth-card is configured > > Then I do this on one of our server ill get this: > > > > [pe...@centos ~]$ ifconfig -a > eth0 Link encap:Ethernet HWaddr 00:11:2F:ED:BA:17 > inet addr:192.168.0.104 Bcast:192.168.0.255 Mask:255.255.255.0 > inet6 addr: fe80::211:2fff:feed:ca17/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:19921184 errors:0 dropped:0 overruns:0 frame:0 > TX packets:18489312 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:1414381688 (1.3 GiB) TX bytes:690690037 (658.6 MiB) > Interrupt:18 Base address:0x2000 > > lo Link encap:Local Loopback > inet addr:127.0.0.1 Mask:255.0.0.0 > inet6 addr: ::1/128 Scope:Host > UP LOOPBACK RUNNING MTU:16436 Metric:1 > RX packets:949 errors:0 dropped:0 overruns:0 frame:0 > TX packets:949 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:128949 (125.9 KiB) TX bytes:128949 (125.9 KiB) > > it must be something wrong with your settings if +ip xxx.xxx.xxx.xxx isnt > working. > > Good Luck sir ! > > Peter > > > > _______________________________________________ > To unsubscribe, edit your list preferences, or view the list archives, > please visit: > http://list.valvesoftware.com/mailman/listinfo/hlds_linux > _______________________________________________ To unsubscribe, edit your list preferences, or view the list archives, please visit: http://list.valvesoftware.com/mailman/listinfo/hlds_linux
