What sucks more for me is that I have to cut and remove the roll at each print. For some reason I cant leave the roll in the printer. If I send another job after the first print, it goes back in and ready to start from the correct spot then just gives the rolloer icon. So I end up cutting with sicsors (not straight), then placing on a table that I have a cutting matt and a T square with xacto, so I lose inches here, and the hassle of removing at every print, unless I send it as a Nesting job, as I use EFI RIP. Not sure how this would pan out with just the HP driver...Although it would be useless for me as I do CMYK proofs 95% of the time off the 130, so...there you have it. But TSquare works as far as the cut goes. A matt cutter is also a nice alternative as mentioned instead of $250-400 for a rotatrim that is used exclusively for this job.
Website: http://groups.yahoo.com/group/HPDesignJet_Printers Post message: [email protected] Subscribe: [EMAIL PROTECTED] Unsubscribe: [EMAIL PROTECTED] List owner: [EMAIL PROTECTED] Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/HPDesignJet_Printers/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/HPDesignJet_Printers/join (Yahoo! ID required) <*> To change settings via email: mailto:[EMAIL PROTECTED] mailto:[EMAIL PROTECTED] <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
