According to adele zhou:
> I installed the htdig in /usr which has 11.4GB Disk
> space free. And tried to use rundig to dig a big file
> http://www-cs.engr.ccny.cuny.edu/~csolb/csc59944/nnet.pdf:
> its size is 5116469.
> The problem is when I set MAX_DOC_SIZE=5116469, I can
> only get 212992. Then I changed MAX_DOC_SIZE to some
> big number. To my sad, no matter how the number big, I
> still can not get the whole file. Although sometimes
> it increased a little and it always said
> !! Error (0): PDF file is damaged - attempting to
> reconstruct xref table...
> !! Error: Couldn't find trailer dictionary
> !! Error: Couldn't read xref table
> I don't know how this come.
I suspect, based on your description above, that you set it
incorrectly. max_doc_size is a config attribute that you set at run
time, not a makefile variable that you set at compile time. It goes
in your htdig.conf file, or similar config file, and not in CONFIG or
Makefile.config, and the format is below (note the name must be lower
case as well!):
max_doc_size: 5116469
--
Gilles R. Detillieux E-mail: <[EMAIL PROTECTED]>
Spinal Cord Research Centre WWW: http://www.scrc.umanitoba.ca/~grdetil
Dept. Physiology, U. of Manitoba Phone: (204)789-3766
Winnipeg, MB R3E 3J7 (Canada) Fax: (204)789-3930
_______________________________________________
htdig-general mailing list <[EMAIL PROTECTED]>
To unsubscribe, send a message to <[EMAIL PROTECTED]> with a
subject of unsubscribe
FAQ: http://htdig.sourceforge.net/FAQ.html
