Lukáš Jirkovský wrote: > Anyway, I've found one quite annoying problem with this. It's not > possible to switch between images in list by using mouse wheel.
I have not played the patch yet so I am not sure what you mean by that? it is not possible to use the mouse wheel in the drop down menu that selects the images on the Control Points tab? this happens even without the patch, at least in Windows. The Control Points tab could use a little bit of attention: I would prefer if the left and right arrow buttons that switch the images in sync would be next to each other so that I don't have to move the mouse that far away when changing direction. I'd put them in the right bottom corner where there is some space and where the "center of gravity" of the controls lies. And I would put the drop-down image number/filename underneath the image rather than on top of it. I would like to be able to start keying in a number in the drop down menu and have it "auto-complete". currently I have to hit TAB twice to move from the one scroll-down to the next, but then keyboard entry does not work. I'd like it to be a single TAB (I guess that in wxWidgets it is possible to determine the order of the widgets, like in most GUI toolkits including the very primitive HTML Forms). Which brings me back to the left-right arrows. I just found out that once selected by tabulating they do react to the ENTER key (blush). Here too I'd like to push TAB (or SHIFT-TAB to go back) only once in between. last but not least, it would be nice if the TAB key would rotate to the beginning of the widgets rather than stop at the end of the widgets list, but I am not sure if this is wxWidgets dependent. I am also not sure if my observations (Windows) are applicable to all OS. the motivation for these small changes is that there are two modes in which the CP tab is used: adding and deleting CPs. When adding CPs, the mouse will inevitably hover over the images and so all of the surface of the images is a target. When deleting CPs, it is much less likely that I will select the CP to delete in the image. It is faster to identify the number of the CP on the image and then click on the table. So all of my clicking (and thus the target) is in the bottom part of the CP tab. moving the mouse up for the selection of images is an action that cost time and usability. Yuv --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "hugin and other free panoramic software" group. A list of frequently asked questions is available at: http://wiki.panotools.org/Hugin_FAQ To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/hugin-ptx -~----------~----~----~----~------~----~------~--~---
