Aha thanks! I figured out my problem. I didn’t realize that the Control Points should be placed on opposite ends of the line that’s being defined. So for example, if I’m defining a horizontal line I should define a point on the left side of the left image and then match that point on the right side of the right image and work my way towards the center. I had thought that I just needed define a point in the left image and then match the point to the same place in the right image.
It wasn’t obvious from the tutorials that I was following that you’re supposed to define the control points like that. Thanks again! Cheers, Dave On Thursday, August 28, 2014 2:55:56 AM UTC-7, Tduell wrote: > > On Thu, 28 Aug 2014 19:02:54 +1000, Dave Thorup <[email protected] > <javascript:>> wrote: > > > > > > Does anyone have any suggestions? > > > > I had a quick look a manual calibration using your image, pretty much as > per the tutorial, and obtained the values of a=0.13, b=-0.451, c=0.364. > I think one could do better using a few more lines, but it might help as > an example. > The .pto for this project is attached. > Hope that helps. > > Cheers, > -- > Regards, > Terry Duell -- A list of frequently asked questions is available at: http://wiki.panotools.org/Hugin_FAQ --- You received this message because you are subscribed to the Google Groups "hugin and other free panoramic software" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/hugin-ptx/5faf55e3-9775-4e11-bb09-d1d47b0d144f%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
