* From Chris <[EMAIL PROTECTED]>
Nope! I`m using an 01v and samson servo amp, neither of which are
distorting at the input or output stages.
Bass boost is set flat.
Even if I perform a factory reset, then plug a set of headphones into each
output in turn, the distortion is still there and its not subtle.
It`s shagged isn`t it!!!!!!
Any one else have this problem?
Chris
>Can any RM1X owners help me!
>I`m experiencing distortion at the main outputs of my RM. Can you do an
>experiment for me?
>With the RM`s volume pot turned fully up, play back the first factory
>preset pattern P01 "PSYCHE 1" section A and tell me if you can hear any
>audio distortion on the outputs.
>Mine is very bad but interestingly, does not appear on the headphone output.
>I know that excessive use of resonance etc can cause this saturation at the
>outs but my RM seems to be more prone than expected.
>Hope you can help
>I'm using a Mackie CR-1604 Mixer to listen to the output of the RM1x. If you
>are using a consumer stereo amp or some sort of cheaper mixer it could very
>well be that your preamp can't take the output of the RM1x. Pro (and even
>semi-pro) equipment usualy has much hotter output then comsumer equipment.
>Both of you, Chris & Michael, didn't tell if they use Bass Boost or not. That
>can make a huge difference ...
___________________________________________________________________________
The Yamaha Hardware Sequencer (qy/rm1x) Mailing List is a free service
provided by TekLab and is open to all members of the Internet community.
For more information about this list and other TekLab Mailing lists visit
our web site: http://www.teklab.com/services/mailinglists/
**> NEW: TekLab Music Technology Forums: http://www.teklab.com/forums/ <**
