Create ZONE1 yourself. Here's an example I just did myself.
ZONE1 - Valid Target zone at desired maintenance level. ZONE2 - Throwaway temporary Target zone for REPORT SYSMODS only. 1) IDCAMS DEFINE new zone CSI called ZONE2. 2) IDCAMS REPRO the GIMZPOOL record. 3) Connect ZONE2 CSI to Global zone (via UCLIN or SMP/E dialogs). 4) Run UNLOAD against ZONE1 to get UCLIN statements for desired FMID(s). For this purpose, the only FMID probably needed is that for the Base Function. 5) Take the UCLIN from step 4 and run it against ZONE2. Remember, ZONE2 is a throwaway zone and will be deleted after generating the desired APPLY statements. 6) Run REPORT SYSMODS INZONE(ZONE1) COMPAREDTO(ZONE2). While this might appear somewhat complicated, I don't think it's that bad. I started figuring this out at 10:10am CT and clicked SEND on this post at 10:49am CT. By the way, my test case was FMID HBB7707 and ZONE1 was MVST100, so this was pretty much a worst-case scenerio for perhaps the largest FMID in z/OS. The generated APPLY statement was 6445 lines. Brian On Thu, 7 Jul 2005 20:54:31 -0600, Paul Gilmartin <[EMAIL PROTECTED]> wrote: >In a recent note, ibm-main said: > >> Date: Fri, 8 Jul 2005 12:39:09 +1000 >> >> > Can I do it without access to ZONE1? (I'll RTFM.) >> >Rats! WOMBATs, actually! > >> There just had to be a reason that John and I both neglected to mention >> this, now didn't there. >> >I'm too old for Aristotelian logic; especially the fuzzy >variety. Hmmm. So if there's no effective answer, I should >expect no followups. But I know better from the VSAM Stats >thread. > >-- gil ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
