Ron,
To make sure I understand, you currently have OWNMEMB designated one way and
now you want to change the name.
So you have in JES2 Parms
On First System you might have
MASDEF OWNMEMB=SYSA
On Next system you might have
MASDEF OWNMEMB=SYSB
On Next system you might have
MASDEFOWNMEMB=SYSC
Now you want to change the names on all of these to something else?
First - I don't think you can blank out the OWNMEMB name. To do change the
OWNMEMB names, you might have to do the following
Change all of your JES2 parms to then new OWNMEMB names across the board.
Also make sure your MEMBER= parms are updated if needed.
Bring down ALL systems at the same time. A JES2 WARM start only happens
when all systems in the JES2 MAS are down. Then IPL one system.
After it is back up, then IPL the rest. If even one system is still active
in the MAS at IPL time then it will be a HOT or QUICK start.
I would do an OFFLOAD of your spool just in-case there are any problems - if
you have to cold start, then your spool data is safe.
Lizette
>
> wanting to change in MASDEF OWNMEMB name from what I have and also then
> MEMBER(1) NAME=
> From what I read ...since I share spool with another system..
> I shut system I want to change the name on>system(A)...
> Change the parm's to what I want...
>
> The other system(B) that is still up I need to change MEMBER(1) NAME to
> NAME=(blank)
> add another MEMBER(3) NAME=XXXX
> Reipl-warm start
>
> Then on system(B) Change MEMBER(1) NAME=(to name I want)
> Change MEMBER(3) NAME=XXXX to NAME=(blank)
> Shut down and warm start again.
>
> Then bring up other system(A) with changes I made...warm start..
>
>
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
