Hi, We have a DS8700 Storage Box. IOCDS works fine during POR and activation. We did a Tape boot with ICKDSF and tried to INIT a disk volume and got the following error.
ICK011E I/O error, Device not attached.2100 where 2100 is the unit address which I used in the INIT command Is there some config that needs to be done on the HMC to make the disk subsystem available? Regards, Srinivas G **************** CAUTION - Disclaimer ***************** This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message. Further, you are not to copy, disclose, or distribute this e-mail or its contents to any other person and any such actions are unlawful. This e-mail may contain viruses. Infosys has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. Infosys reserves the right to monitor and review the content of all messages sent to or from this e-mail address. Messages sent to or from this e-mail address may be stored on the Infosys e-mail system. ***INFOSYS******** End of Disclaimer ********INFOSYS*** ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@bama.ua.edu with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html