Hi there, I do not know if this is the right list to post this, but I'm trying anything for help. I have got a very urgent situation.
I am trying to have a configuration like - VTAM1 - NCP1 - NCP2 NCP1 is loaded in a channel attached 3745. NCP2 will be on a link attached 3745. In the NCP generation and loading guide the following is stated: You can perform a remote initial load over a TSS or HPTSS SDLC link or over a nonswitched X.21 link if the remote communication controller has the remote IPL ports defined. The remote initial load can transfer the NCP or PEP load module from the host, activate it, and save it on the remote hard disk. There is a minimum release requirement of NCP V4R2 with VTAM V3R2 in order to save the module to the remote hard disk. I have created remote IPL port using LKP function in the communication controller of NCP2 - the parameters for the Port are: Line Address: 35 Direct/External: External Duplex: D Enable Timer: 0 (Timeout yok) Transmit two flags: y Transmit flags between frames: y NRZI: y DX facility:y Switched: N Ring: N Answer: N Echo: N Datarate: High External Line Speed: Other (not 9600 or 56K my connection is 19.2K DialUp with modems dialing each other) SDLC Controller Address: C1 (I have coded this - but could not get from the guides what this is used for) So what should I do now? Create a line and PU (Type4) in NCP1 - for this connection? I have made so, but I can not see the PU as online on my VTAM, when there is no NCP loaded in the remote controller. Can anybody help me with the procedure- the guides all keep it as trivial, just create remote IPL port, and load, but no procedure. I will appreciate for any contribution. ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
