I don't know what hardware you have available... If you have peer mode capability you need to use ICP for the "channel path type" otherwise for compatibility mode if I recall correctly you need to use ICR/ICS. Unless you want to override the values the control unit and device numbers are suggested for you when perform the "connect to CF channel path." This is not a physical connection, but do give up two channel paths.
Regards, Kevin -----Original Message----- From: IBM Mainframe Discussion List [mailto:[EMAIL PROTECTED] On Behalf Of munif sadek Sent: Thursday, August 24, 2006 2:49 AM To: [email protected] Subject: HCD problem with CFR-CFS pair I have defined CFR(Dedicated) and CFS(Shared) channels for my Production CPC and when I am connecting them, its failing with following HCD message: Processor X cannot be connected via different control units to the coupling facility - partition CF01 of processor X. I am afraid I have/can not define CU attached to CFR/CFS channels. all helps are much appreciated. regards, Munif. ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
