I use a GTF SLIP trace: 1. Issue the command $DMODULE(xxxxxxxx) to determine the module's location in storage (rrrrrrrrr,ssssssss).
2. Issue a SLIP command similar to: SLIP SET,IF,ID=JSEX,RANGE=(rrrrrrrr,ssssssss), ACTION=TRACE,MODE=HOME, TRDATA=(STD,REGS),END 3. Start GTF with TRACE=SLIP. On Fri, 13 Oct 2006 13:17:23 -0500, Dave Kopischke <[EMAIL PROTECTED]> wrote: >On Fri, 13 Oct 2006 10:00:14 -0700, Gibney, Dave <[EMAIL PROTECTED]> wrote: > >> Check out SHARE Presentations from Skip Robinson and Tom Wasik >> > >I went through Skips SHARE presentation and made some changes to ignore >what comes in R1 and base all addresses off of XPL fields. Still S0C4's. > >How does everyone go about debugging these exits ??? I finally got a trace >to work, but for EXIT52 all I get is register contents before and after. >No clues as to what might be causing the S0C4. Not much to go on for a >JES2/Assembler newbie. > >---------------------------------------------------------------------- >For IBM-MAIN subscribe / signoff / archive access instructions, >send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO >Search the archives at http://bama.ua.edu/archives/ibm-main.html >========================================================================= ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
