Walter, >I thought a Sysplex master console *should* have MSCOPE=*ALL and its >route code 1-10,12-128 were more than appropriate. HC has a different >opinion, though.
Actually, *that* check says: Checks that each MCS/SMCS/EMCS console is not defined with multi-system message scopes AND receiving all routing codes (or all except routing code 11). If you need to have rc 17-128 going to that console, try changing the mscope from *ALL to naming the systems individually, ie. if your sysplex contains of sysa,sysb,sysc,sysd, then vary that console an mscope of sysa,sysb,sysc,sysd instead of *all. That might stop HC from complaining. To be fair, sending too many messages across a plex can generate a lot of XCF traffic. We have ours now defined to only receive rc 1-16 except 11. HC probably checks as 'reasonable' what would be sent to an autoactivated console (I am almost sure that rc17-128 are not in that range). Our *All console only receives rc13 these days (which I have to set via mpfexit on a message-by-message basis). Regards, Barbara -- Psssst! Schon vom neuen GMX MultiMessenger gehört? Der kanns mit allen: http://www.gmx.net/de/go/multimessenger ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
