Hi George, Thanks for your information. While I use the Freeze & run command, all path are deleted from our primary site. The primary site disk are in "SUSPEND(A)" and secondary site disk are in "DUPLEX". Firstly, I need to establish the path then RECOVERY the secondary site DUPLEX status to SIMPLEX, Finally, I use the mode(failback) to RESYNC all changed bit from primary site to secondary site.
Is it correct steps??? or I have some wrong .. Why? the primary site suspend use failback and second site suspend use MODE(RESYNC)?? Best regards Tommy On 2/5/08, [EMAIL PROTECTED] <[EMAIL PROTECTED]> wrote: > > On Feb 4, 10:12 pm, [EMAIL PROTECTED] (Tommy Tsui) wrote: > > hi all, > > > > I have a question on how to resync the change bit to remote site > after > > CGROUP FREEZE & RUN are executed. Is it using MODE(RESYNC) or FAILBACK > or > > others? > > > > any comment will be appreciated > > > > Tommy > > > > ---------------------------------------------------------------------- > > For IBM-MAIN subscribe / signoff / archive access instructions, > > send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO > > Search the archives athttp://bama.ua.edu/archives/ibm-main.html > Hi Tommy, > You would normally use MODE(RESYNC). Failback is used if a Failover > was done. The way to tell is to check the status of the secondary > device. If it is SEC-SUSP, use MODE(RESYNC) whereas if it is PRI-SUSP, > use FAILBACK. > > Regards, George Kozakos > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
