Thanks Carmen. I'll post the results when I try an IPL of that new system and SMS starts up
-----Original Message----- From: IBM Mainframe Discussion List <IBM-MAIN@LISTSERV.UA.EDU> On Behalf Of Carmen Vitullo Sent: Monday, May 18, 2020 3:05 PM To: IBM-MAIN@LISTSERV.UA.EDU Subject: Re: Creating new SMS environment in a monoplex Hi Bob, been a while for me also, but in my current sysplex I have systems defined that no longer exist, my ACS routines do not check for these systems. my base configuration has 4 systems in the plex, only 3 exists, not sure this helps you but I think you are on the right track Carmen Vitullo ----- Original Message ----- From: "Robert B. Richards" <000001c91f408b9e-dmarc-requ...@listserv.ua.edu> To: IBM-MAIN@LISTSERV.UA.EDU Sent: Monday, May 18, 2020 1:36:29 PM Subject: Creating new SMS environment in a monoplex It has been a few decades since I have created a new SMS environment. Current environment is parallel sysplex replete with CFs and lots of lpars. I am trying to create a simple SMS environment that will be part of a monoplex consisting on one lpar. I did the following: 1. Defined the new SYSNAME into the base configuration in ISMF and activated same. D SMS verified it was defined and not active 2. A REPRO of the SCDS into a new SCDS dataset (Alter/newname to correct usercat) 3. Issued a SETSMS SAVEACDS(also using a SSA connector that I subsequently ALTER NEWNAME the new ACDS into a new usercat that is connected to a new mastercat) 4. Defined an empty COMMDS that I also performed an alter/newname to get the desired COMMDS dataset name. My boss says the ACDS is aware of the original sysplex environment and my gyrations of trying to make the above work in a monoplex will not succeed. Who is right? Will it work or not? Bob ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN