Re: How to compare parameters in one z/Os with parameters in another z/OS

Sun, 13 Jun 2021 18:29:06 -0700 

Dear


 We could write a program to handle specific parameters and values before 
comparing them against the target library


We found that some parameters are just defined  in a different order in 
different z/os, but they are actually the same definition


Some parameter definitions have different starting columns, and they also are 
the same definition


We don't know how to handle this situation. Do we need to make sure they are in 
the same order?


Thanks a lot!


Jason Cai





------------------ Original ------------------
From:                                                                           
                                             "IBM Mainframe Discussion List"    
                                                                                
<[email protected]&gt;;
Date:&nbsp;Mon, Jun 14, 2021 08:01 AM
To:&nbsp;"IBM-MAIN"<[email protected]&gt;;

Subject:&nbsp;Re: How to compare parameters in one z/Os with parameters in 
another z/OS



There is a utility program (IEBCOMPR) and functions like SuperCompare to do
this.&nbsp; It is quite trivial.

Unless you mean that these libraries are not truly comparable in which case
no comparison is possible.&nbsp; Under those conditions you would have to have a
program which could have specific parameters and values identified and then
compared against the target library.&nbsp; To the best of my knowledge, that is
certainly not freely available.

Adam

P.S. I am assuming that the notion of symbols has been properly pursued and
evaluated.


-----Original Message-----
From: IBM Mainframe Discussion List <[email protected]&gt; On Behalf Of
ibmmain
Sent: Sunday, June 13, 2021 4:51 PM
To: [email protected]
Subject: How to compare parameters in one z/Os with parameters in another
z/OS

Hi all


&amp;nbsp;We want to make sure two z/OS use the same
parameters(PARMLIB,VTAMLST,and so on)&amp;nbsp;


Because there is some parameter which is multiline in member, it isn't easy
to compare them.
&amp;nbsp;&amp;nbsp;
Is there any way to compare&amp;nbsp; parameters in one z/Os with parameters in
another z/OS


&amp;nbsp;Any thoughts/comments/suggestions would be greatly appreciated


Best Regards,


Jason Cai

----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions, send email
to [email protected] with the message: INFO IBM-MAIN

----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN

----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN

Reply via email to