Nope. DIAGxx has AUTOIPL MVS(LAST). PPRC isn't being used here. AUTOIPL works almost all the time. It failed today with that message. Was just wondering why.
Mark Jacobs Sent from ProtonMail, Swiss-based encrypted email. GPG Public Key - https://api.protonmail.ch/pks/lookup?op=get&[email protected] ‐‐‐‐‐‐‐ Original Message ‐‐‐‐‐‐‐ On Thursday, November 4th, 2021 at 9:08 PM, Attila Fogarasi <[email protected]> wrote: > The obvious reason is DIAGxx has AUTOIPL statement with that address. > > Maybe changed by SET command? Otherwise all I can think of is PPRC maybe > > can do this, but unlikely. > > On Fri, Nov 5, 2021 at 11:43 AM Mark Jacobs < > > [email protected]> wrote: > > > One of out systems went into a wait state today and autoipl was attempted. > > > > It failed with this message (from the HMC Hardware Events log) > > > > A load failure occurred on logical partition XXXX because a device address > > > > control block (DACB) was not found. Unit address = 5810. > > > > That unit address is not in our IODF. A manual activation was needed to > > > > bring it back up. I'm just curious how/why this error occurred. > > > > Mark Jacobs > > > > Sent from ProtonMail, Swiss-based encrypted > > > > email. > > > > GPG Public Key - > > > > https://api.protonmail.ch/pks/lookup?op=get&[email protected] > > > > For IBM-MAIN subscribe / signoff / archive access instructions, > > > > send email to [email protected] with the message: INFO IBM-MAIN > > For IBM-MAIN subscribe / signoff / archive access instructions, > > send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
