Yes, but used <> REGION.
Or rather used <=REGION :-)
However AFAIK SMF30 contains the limits.
--
Radoslaw Skorupka
Lodz, Poland
W dniu 27.05.2023 o 00:35, Mike Schwab pisze:
If you can look at a job that is ended, the job log step completion
message shows the amount used 24/31/64 bit areas.
On Fri, May 26, 2023 at 11:44 AM Radoslaw Skorupka
<[email protected]> wrote:
W dniu 26.05.2023 o 16:39, Phil Smith III pisze:
FYI, Radoslaw, that was getting the "current values 'from inside' of the task",
to use your phrasing. So you could make this work.
That's what I understood. Thank you again for the help.
However my goal was rather to start, let's say CICS region or some job
(with no changes) and find out effective REGION/MEMLIMIT settings.
I was also pointed to some Mark Zelden's rexx utility which read the
same control blocks. (Thanks!)
However finally I found some new SMFLIM keyword, which should cause
message ...and maybe I'll find some time next Monday to try it.
Regards
--
Radoslaw Skorupka
Lodz, Poland
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
