On Mon, 11 Sept 2023 at 09:33, Joseph Reichman <[email protected]> wrote:
> I have the following lines of code which basically sets up the parameter > list to an ESTAE and calls it > Later on when I populate Parse Parameter list and call IKJPARS I get a > s0c4 pic 10 right after the BALR There's no BALR in the code snippets you've shown. I'll assume you mean BASR. > When I comment out the code below (that sets up the ESTAE parameter list) > everything with PARS works great > I check and double checked there is no storage overlay, I am just looking > for guidance how to debug this Two basic approaches: Top Down and Bottom Up. Start at the bottom - what is the failing address causing your PIC 10? Does it look plausible for the AMODE you're in at the time? Which instruction actually failed? Is the failing address (or a near or left-truncated version of it) in a register? Etc... If that hasn't made the problem obvious, then you may have collected enough information to work from the top down. If it's true that the ESTAE is provoking the failure, then what does it change, i.e. how could anything it does affect the result of calling IKJPARS? Etc... Tony H. ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
