I'll ask if you did the UPGRADE in the same run as the RECEIVE process. The example from the z/OS SMP/E Commands manual shows the UPGRADE command as part of the same run.
The following is from the SMP/E command manual. SET BDY(ZOSTGT). UPGRADE. BYPASS(HOLDSYS) CHECK. In this example, the UPGRADE command indicates incompatible changes may be made to SMP/E data sets. If UPGRADE is not specified, then SMP/E stops any processing that would make incompatible changes to SMP/E data sets. In this example, the APPLY command would very likely fail if the UPGRADE command were not first run. However, once the UPGRADE command is run for a particular zone, then all SMP/E commands are authorized to make incompatible changes to all SMP/E data sets in that zone. Paul -----Original Message----- From: IBM Mainframe Discussion List <IBM-MAIN@LISTSERV.UA.EDU> On Behalf Of Steely.Mark Sent: Friday, March 29, 2024 5:49 PM To: IBM-MAIN@LISTSERV.UA.EDU Subject: Re: SMP/E I did perform the upgrade command on the global and target zone and nothing happen. The SMP/e level stayed the same and the receive still failed with the same error. -----Original Message----- From: IBM Mainframe Discussion List <IBM-MAIN@LISTSERV.UA.EDU> On Behalf Of Tom Marchant Sent: Friday, March 29, 2024 5:20 PM To: IBM-MAIN@LISTSERV.UA.EDU Subject: Re: SMP/E CAUTION! EXTERNAL SENDER! STOP, ASSESS, AND VERIFY Do you know this person? Were you expecting this email? If not, report it using the Report Phishing Button! Just issue the UPGRADE command. IIRC FIXCAT support was added to SMP/E around 2008. Your global zone must have been created with a release of SMP/E before that. -- Tom Marchant On Fri, 29 Mar 2024 21:59:49 +0000, Steely.Mark <steely.m...@ace.aaa.com> wrote: >I recently received this message: GIM58903W SMP/E COULD NOT PROCESS A >++HOLD FIXCAT MCS BECAUSE IT WOULD HAVE MADE A CHANGE TO THE GLOBAL ZONE THAT > > CANNOT BE PROCESSED COMPLETELY BY PRIOR LEVELS OF SMP/E. USE THE > UPGRADE COMMAND TO ALLOW SMP/E TO MAKE > > SUCH CHANGES. > >The message says you can execute the upgrade command. ( I am not sure >if I can do that without having some type of maintenance applied) > >It has been a while since I upgraded SMP/e independently of a Service Pack or >some other type of installation. > >I thought I would just install the new release of SMP/e - for some reason I >can't find it on ShopzSeries. > >I have tried to look all over the internet for the answer, but I always gets >hits on installing other products using SMP/e. > >We are currently at SMP/E 37.13 >Our SMP/E is 2.4 FMID - HMP1K00. > >What should I do ? ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN