I just noticed that on abend I was in amode 64 and retry in amode 31 but this should have no effect as r13 was a 24 bit address the stimer exit did get control in amode 64 I saved only 31 bit registers
> On May 3, 2024, at 1:00 PM, Seymour J Metz <[email protected]> wrote: > > That stems from a bad address. Are you in the correct address mode? Could > you have done a premature FREEMAIN? > > -- > Shmuel (Seymour J.) Metz > http://mason.gmu.edu/~smetz3 > עַם יִשְׂרָאֵל חַי > נֵ֣צַח יִשְׂרָאֵ֔ל לֹ֥א יְשַׁקֵּ֖ר > > ________________________________________ > From: IBM Mainframe Discussion List <[email protected]> on behalf of > Joseph Reichman <[email protected]> > Sent: Friday, May 3, 2024 12:55 PM > To: [email protected] > Subject: 0C4 pic 11 in stimer exit on retry > > Hi > > I have recovery routine which got control on abend of stimer exit irb > > On retry I am getting S0C4 PIC 11 reloading my registers from the system > primed r13 I check 13 on input before the abend and at the retry point and > it has the same value > > When I abend in the stimer exit does the system do anything to my save area > R13 > > Thanks > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
