Was 24 bit number like a TCB or RB first byte 00 it’s an address given by the system the doc says
Thanks Get Outlook for iOS<https://aka.ms/o0ukef> ________________________________ From: IBM Mainframe Discussion List <[email protected]> on behalf of Tom Marchant <[email protected]> Sent: Friday, May 3, 2024 4:00:15 PM To: [email protected] <[email protected]> Subject: Re: 0C4 pic 11 in stimer exit on retry You didn't say that the high 32 bits of R13 was zero. Were they? -- Tom Marchant On Fri, 3 May 2024 13:15:12 -0400, Joseph Reichman <[email protected]> wrote: >I just noticed that on abend I was in amode 64 and retry in amode 31 but this >should have no effect as r13 was a 24 bit address the stimer exit did get >control in amode 64 I saved only 31 bit registers > > > > >> On May 3, 2024, at 1:00 PM, Seymour J Metz <[email protected]> wrote: >> >> That stems from a bad address. Are you in the correct address mode? Could >> you have done a premature FREEMAIN? >> >> -- >> Shmuel (Seymour J.) Metz >> http://mason.gmu.edu/~smetz3 >> עַם יִשְׂרָאֵל חַי >> נֵ֣צַח יִשְׂרָאֵ֔ל לֹ֥א יְשַׁקֵּ֖ר >> >> ________________________________________ >> From: IBM Mainframe Discussion List <[email protected]> on behalf of >> Joseph Reichman <[email protected]> >> Sent: Friday, May 3, 2024 12:55 PM >> To: [email protected] >> Subject: 0C4 pic 11 in stimer exit on retry >> >> Hi >> >> I have recovery routine which got control on abend of stimer exit irb >> >> On retry I am getting S0C4 PIC 11 reloading my registers from the system >> primed r13 I check 13 on input before the abend and at the retry point and >> it has the same value >> >> When I abend in the stimer exit does the system do anything to my save area >> R13 >> >> Thanks ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
