On 6/18/2013 12:28 PM, Wayne Driscoll wrote:
You could start by looking at any control blocks pointed to by SSCTSUSE or
SSCTSUSE2 for eye-catchers. Then you could look at the field pointed to by
SSCTSSVT. If the subsystem supports IEFSSREQ calls, the SSVT will contain
a table, followed by the address of the various routines. Hopefully one of
the routines will have identifying information within it.
To find out who is using this subsystem, either:
o Use a PER SLIP IF to monitor the target routine addresses or
o (my favorite) use a "core" ZAP utility to turn on the last bit of each
address and see who blows up :)
--
Edward E Jaffe
Phoenix Software International, Inc
831 Parkview Drive North
El Segundo, CA 90245
http://www.phoenixsoftware.com/
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
