Barbara, Is this in the ARCCMDxx member? Or is it being issued as a command?
If in the ARCCMDxx can you try doing a F dfhsmtaskname,SETSYS TAPEMIGRATION(NONE) and let us know what happens? If in the ARCCMDxx can you post a few lines above and below the Tapemigration line? DFHSM was not meant to be intuitive. So it takes some digging and reviewing the DFHSM Storage Admin Guide to try and figure out why things are not working. Also, do you have an OCDS present? Or is it dummy? Note: From the STG Admin Guide: If you do not intent to use Tape, do not specify TAPEMIGRATION. If you do, an Offline control dataset is required. Lizette -----Original Message----- From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf Of [email protected] Sent: Wednesday, July 03, 2013 11:13 PM To: [email protected] Subject: Re: Installing HSM or rather: DFHSM woes Alan, > You can issue F DFHSM,RELEASE MIGRATION, but it will most likely be held again immediately when the first migration is attempted. I got up the nerve to issue the command this morning (after all, the cycle is still defined to not start by itself). HSM said: ARC0100I RELEASE COMMAND COMPLETED Now I manually migrated one data set. It works! Recall also worked. (I'm happy.) Now I need to get up the nerve to have everything start automatically... Can anybody tell me why SETSYS TAPEMIGRATION(NONE) gets ARC0103I INVALID SETSYS PARAMETER TAPEMIGRATION ? Barbara ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
