Ok. Thanks for the replies. Looks like I have no choice but to deactivate/activate.
Regards, Srinivas G -----Original Message----- From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf Of Staller, Allan Sent: Monday, September 16, 2013 6:17 PM To: [email protected] Subject: Re: Processor for each LPAR If you have reserved processors in the activation profile for that LPAR they can be added dynamically. IIRC, however, to change the number of reserved processors will require a deactivate/activate for that LPAR. HTH, <snip> On the HMC , is there a way where I can change the number of processors allocated , either dedicated or not dedicated, to a particular LPAR without having to deactivate and activate? The Change Logical Partition Control function only allows Processor Weightage to be changed. </snip> ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN **************** CAUTION - Disclaimer ***************** This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message. Further, you are not to copy, disclose, or distribute this e-mail or its contents to any other person and any such actions are unlawful. This e-mail may contain viruses. Infosys has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. Infosys reserves the right to monitor and review the content of all messages sent to or from this e-mail address. Messages sent to or from this e-mail address may be stored on the Infosys e-mail system. ***INFOSYS******** End of Disclaimer ********INFOSYS*** ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
