I use OUTLIM on the individual SYSOUT= statements to force an S722. But that can be PITA.
On Tue, Mar 11, 2014 at 1:54 PM, Barry Merrill <ba...@mxg.com> wrote: > It appears that there is no JCL option for an individual job that > can be enabled to cause the job to terminate when > /*JOBPARM LINES=10 > is used and the job has produced 10,001 lines of output. > > I can only find references to JES2 EXIT 9 where the decision > is made for lines exceeded. > > I never needed this before, but then I never completely filled > my spool before with a runaway job. > > The circumvention was to point SYSOUT file to a CYL(1) disk > file and force the B37 ABEND to get control of the job and > to read the log messages. > > Barry Merrill > > > Herbert W. "Barry" Merrill, PhD > President-Programmer > MXG Software > Merrill Consultants > 10717 Cromwell Drive > Dallas, TX 75229 > ba...@mxg.com > > http://www.mxg.com - FAQ has Most Answers > ad...@mxg.com - invoices/PO/Payment > supp...@mxg.com - technical > tel: 214 351 1966 - expect slow reply, use email > fax: 214 350 3694 - prefer email, still works > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN > -- There is nothing more pleasant than traveling and meeting new people! Genghis Khan Maranatha! <>< John McKown ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN
