Why is it a PITA? Is there a typical value you use on the OUTLIM?
Please, thanks,
Graham Hobbs
On 11/03/2014 3:14 PM, John McKown wrote:
I use OUTLIM on the individual SYSOUT= statements to force an S722. But
that can be PITA.
On Tue, Mar 11, 2014 at 1:54 PM, Barry Merrill <[email protected]> wrote:
It appears that there is no JCL option for an individual job that
can be enabled to cause the job to terminate when
/*JOBPARM LINES=10
is used and the job has produced 10,001 lines of output.
I can only find references to JES2 EXIT 9 where the decision
is made for lines exceeded.
I never needed this before, but then I never completely filled
my spool before with a runaway job.
The circumvention was to point SYSOUT file to a CYL(1) disk
file and force the B37 ABEND to get control of the job and
to read the log messages.
Barry Merrill
Herbert W. "Barry" Merrill, PhD
President-Programmer
MXG Software
Merrill Consultants
10717 Cromwell Drive
Dallas, TX 75229
[email protected]
http://www.mxg.com - FAQ has Most Answers
[email protected] - invoices/PO/Payment
[email protected] - technical
tel: 214 351 1966 - expect slow reply, use email
fax: 214 350 3694 - prefer email, still works
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
