Hello Jake, Looks like your spool volume name should begin with SPOOL. So it would be SPOOL1, SPOOL2, etc (or any other following letter/number).
Lucas 2014-05-22 8:34 GMT-03:00 Jake anderson <[email protected]>: > Hello All, > > > I am trying to add spool volume with a command : $SSPOOL(TSO11V), but it > gives out me the below error : > > $HASP003 RC=(04),S SPOOL(TSO11V) - CONTAINS AN INVALID > $HASP003 SUBSCRIPT > > > As an initial message from IBM manual : > > 04*CONTAINS AN INVALID SUBSCRIPT[, RANGE IS (xxxx-yyyy)]* > > The specified subscript value is either outside the allowable range or is > not defined by your installation. The valid range of the subscript is > displayed. This code can also be displayed if a subscript should have been > specified but was not. > > Currently system has only 1 spool volume and the JES2PARM has the > limitation of 32. > > > JES2PARM > > SPOOLDEF BUFSIZE=3992, > DSNAME=SYS1.HASPACE, > FENCE=NO, > RECINCR=2, > SPOOLNUM=32, > TGBENUM=10, > TGNUM=16288, > TGSIZE=30, > TGWARN=80, > TRKCELL=3, > VOLUME=SPOOL > > Allocation : > > //ALLOC DD DSN=SYS1.HASPACE,DISP=(NEW,KEEP,KEEP), > // SPACE=(CYL,900),UNIT=3390,VOL=SER=TSO11V, > // DCB=(DSORG=PS,RECFM=F,LRECL=4096,BLKSIZE=3992), > // DSNTYPE=LARGE > > Could someone point me where I have gone wrong. > > Jake > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
