Hello Lucas, I am just curious that previous Dataset was allocated on a volume "MVS11B" and the spool is working with that Volume.
On Thu, May 22, 2014 at 5:12 PM, Lucas Rosalen <[email protected]>wrote: > Hello Jake, > > Looks like your spool volume name should begin with SPOOL. So it would be > SPOOL1, SPOOL2, etc (or any other following letter/number). > > Lucas > > > 2014-05-22 8:34 GMT-03:00 Jake anderson <[email protected]>: > > > Hello All, > > > > > > I am trying to add spool volume with a command : $SSPOOL(TSO11V), but it > > gives out me the below error : > > > > $HASP003 RC=(04),S SPOOL(TSO11V) - CONTAINS AN INVALID > > $HASP003 SUBSCRIPT > > > > > > As an initial message from IBM manual : > > > > 04*CONTAINS AN INVALID SUBSCRIPT[, RANGE IS (xxxx-yyyy)]* > > > > The specified subscript value is either outside the allowable range or is > > not defined by your installation. The valid range of the subscript is > > displayed. This code can also be displayed if a subscript should have > been > > specified but was not. > > > > Currently system has only 1 spool volume and the JES2PARM has the > > limitation of 32. > > > > > > JES2PARM > > > > SPOOLDEF BUFSIZE=3992, > > DSNAME=SYS1.HASPACE, > > FENCE=NO, > > RECINCR=2, > > SPOOLNUM=32, > > TGBENUM=10, > > TGNUM=16288, > > TGSIZE=30, > > TGWARN=80, > > TRKCELL=3, > > VOLUME=SPOOL > > > > Allocation : > > > > //ALLOC DD DSN=SYS1.HASPACE,DISP=(NEW,KEEP,KEEP), > > // SPACE=(CYL,900),UNIT=3390,VOL=SER=TSO11V, > > // DCB=(DSORG=PS,RECFM=F,LRECL=4096,BLKSIZE=3992), > > // DSNTYPE=LARGE > > > > Could someone point me where I have gone wrong. > > > > Jake > > > > ---------------------------------------------------------------------- > > For IBM-MAIN subscribe / signoff / archive access instructions, > > send email to [email protected] with the message: INFO IBM-MAIN > > > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
