How was the exit installed IPL or SETPROG? If IPL, is the exit defined in PROGxx? (based on the CSV421I message) Is there an EXIT statement for IEFUJI in PROGxx?
If installed via IPL and not in PROGxx, replace the exit with a renamed copy of IEFBR14 and re-ipl Is it possible this is just a "ordinary" JCL error in the logon proc? What does the console log say? You have shown the tso terminal messages and the output of the setprog command, but not what the log has said about the logon. If ACF2, there should be some messages on the console log, indicating possible causes of failure. <snip> I have this situation/condition. I installed an IEFUJI exit and it is preventing logon to TSO, and I can not figure out how to remedy this situation. I receive the following series of messages when attempting logon. IKJ56455I SPJRJ LOGON IN PROGRESS AT 11:38:42 ON JUNE 25, 2014 IKJ56457I LOGON FAILED JCL ERROR IN LOGON PROCEDURE IKJ56470I SPJRJ LOGGED OFF TSO AT 11:38:42 ON JUNE 25, 2014 ACF82931 ACF2, LOGON ATTEMPT FAILED. SEE MESSAGE MANUAL FOR POSSIBLE CAUSES ACF82904 ACF2, SESSION TERMINATED. I have attempted to delete the exit, i.e. SETPROG EXIT,DELETE,EXITNAME=IEFUJI,MODNAME=IEFUJI. This results in: CSV421I MODULE IEFUJI WAS NOT DELETED FROM EXIT IEFUJI. EXIT NOT DEFINED </snip> ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
