Did you POR with the correct IOCDS?
----- Original Message ----- From: "mf db" [[email protected]] Sent: 10/12/2014 06:26 PM ZE5B To: [email protected] Subject: Re: LPAR loaded but no response Corrective action : Verify that the device exists for the logical partition in the IOCDS. If the problem continues, select Service. Is there a way to check if a device do exist ? On Sun, Oct 12, 2014 at 6:18 PM, mf db <[email protected]> wrote: > I see the below message in HW message window, > > Initial Program Load (IPL) failed. The load address is not defined in > the input/output configuration data set (IOCDS). > > > There was no change even before IPL but not sure why I am getting the > above message after the Power on Reset. > > > On Sun, Oct 12, 2014 at 5:54 PM, R.S. <[email protected]> > wrote: > >> W dniu 2014-10-12 o 09:34, mf db pisze: >> >> Hi >>> >>> There are two images in sysplex. When i tried loading the lpar i got >>> success message in HMC. I do not get any response on console either in >>> OSA >>> console or HMC operating message windows. >>> Is there other way to check the output of LPAR activation ? >>> >>> Some of the reasons: >> There is another console with IEA101A message awaiting your resonse. >> IPL failed with some wait state message (you should ee it as HW message >> on HMC). >> IPL succeded without your intervention (IEA101A was supressed by >> combination of IMSI and system LOAD/PARMLIB parameters). >> >> -- >> Radoslaw Skorupka >> Lodz, Poland >> >> >> >> >> >> >> --- >> Treść tej wiadomości może zawierać informacje prawnie chronione Banku >> przeznaczone wyłącznie do użytku służbowego adresata. Odbiorcą może być >> jedynie jej adresat z wyłączeniem dostępu osób trzecich. Jeżeli nie jesteś >> adresatem niniejszej wiadomości lub pracownikiem upoważnionym do jej >> przekazania adresatowi, informujemy, że jej rozpowszechnianie, kopiowanie, >> rozprowadzanie lub inne działanie o podobnym charakterze jest prawnie >> zabronione i może być karalne. Jeżeli otrzymałeś tę wiadomość omyłkowo, >> prosimy niezwłocznie zawiadomić nadawcę wysyłając odpowiedź oraz trwale >> usunąć tę wiadomość włączając w to wszelkie jej kopie wydrukowane lub >> zapisane na dysku. >> >> This e-mail may contain legally privileged information of the Bank and is >> intended solely for business use of the addressee. This e-mail may only be >> received by the addressee and may not be disclosed to any third parties. If >> you are not the intended addressee of this e-mail or the employee >> authorized to forward it to the addressee, be advised that any >> dissemination, copying, distribution or any other similar activity is >> legally prohibited and may be punishable. If you received this e-mail by >> mistake please advise the sender immediately by using the reply facility in >> your e-mail software and delete permanently this e-mail including any >> copies of it either printed or saved to hard drive. >> >> mBank S.A. z siedzibą w Warszawie, ul. Senatorska 18, 00-950 Warszawa, >> www.mBank.pl, e-mail: [email protected] Sąd Rejonowy dla m. st. Warszawy >> XII Wydział Gospodarczy Krajowego Rejestru Sądowego, nr rejestru >> przedsiębiorców KRS 0000025237, NIP: 526-021-50-88. Według stanu na dzień >> 01.01.2014 r. kapitał zakładowy mBanku S.A. (w całości wpłacony) wynosi >> 168.696.052 złote. >> >> >> ---------------------------------------------------------------------- >> For IBM-MAIN subscribe / signoff / archive access instructions, >> send email to [email protected] with the message: INFO IBM-MAIN >> > > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
