While I would never rule out the possibility, I don't think that's the case. If I have no SYSPRINT override in the utility definition for the assembler or the linkage editor, and I have the DDDEF for SYSPRINT defined as SYSOUT=* in the target zone, the usermod APPLYs perfectly. No errors, on the assembly or the link.
All I'm changing at this point is the operating "environment" for SMP/E. I'm not changing the usermod in any way. Charles (Chuck) Hardee Senior Systems Engineer/Database Administration EAS Information Technology Thermo Fisher Scientific 300 Industry Drive | Pittsburgh, PA 15275 Phone +1 (724) 517-2633 | Mobile +1 (412) 877-2809 | FAX: +1 (412) 490-9230 [email protected] | www.thermofisher.com WORLDWIDE CONFIDENTIALITY NOTE: Dissemination, distribution or copying of this e-mail or the information herein by anyone other than the intended recipient, or an employee or agent of a system responsible for delivering the message to the intended recipient, is prohibited. If you are not the intended recipient, please inform the sender and delete all copies. -----Original Message----- From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf Of Shmuel Metz (Seymour J.) Sent: Tuesday, November 11, 2014 8:23 AM To: [email protected] Subject: Re: SMP/E APPLY output capture question In <9b26bc6a6df52d4483dd73b1fe7b4b068b3e557...@uspho-mxvs07.amer.thermo.com>, on 11/11/2014 at 05:54 AM, "Hardee, Chuck" <[email protected]> said: >I have tried supplying a defining a OUTPUT statement at the start >of my job and then supplying a SYSPRINT DD with an OUTPUT= naming >the OUTPUT statement's name. That didn't work, and I didn't get any >indication from SMP/E as to errors, but my usermod was not applied. Then you have other problems besides SYSPRINT. Check your packaging. >Anyone have any ideas? T? -- Shmuel (Seymour J.) Metz, SysProg and JOAT ISO position; see <http://patriot.net/~shmuel/resume/brief.html> We don't care. We don't have to care, we're Congress. (S877: The Shut up and Eat Your spam act of 2003) ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
