As I replied to Shmuel Metz, I am using a usermod that APPLYs just fine when I don't attempt to capture the output using any means.
The GLOBAL zone defines no override for the assembler or link utilities and the DDDEFs for SYSPRINT in the target zone says SYSOUT=*. With that arrangement, the usermod APPLYs perfectly, I get an assembly listing on SYSPRINT and a linkage report on SYS00008. Charles (Chuck) Hardee Senior Systems Engineer/Database Administration EAS Information Technology Thermo Fisher Scientific 300 Industry Drive | Pittsburgh, PA 15275 Phone +1 (724) 517-2633 | Mobile +1 (412) 877-2809 | FAX: +1 (412) 490-9230 [email protected] | www.thermofisher.com WORLDWIDE CONFIDENTIALITY NOTE: Dissemination, distribution or copying of this e-mail or the information herein by anyone other than the intended recipient, or an employee or agent of a system responsible for delivering the message to the intended recipient, is prohibited. If you are not the intended recipient, please inform the sender and delete all copies. -----Original Message----- From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf Of Kurt Quackenbush Sent: Tuesday, November 11, 2014 8:54 AM To: [email protected] Subject: Re: SMP/E APPLY output capture question > ... I didn't get any > indication from SMP/E as to errors, but my usermod was not applied. You received no errors, but the USERMOD was not applied? What exactly did SMP/E tell you? It sounds to me like id didn't actually perform any assemblies or link edits. If not, then maybe that is why your redirected output didn't work as you hoped. Kurt Quackenbush -- IBM, SMP/E Development ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
