Hi list,
I have a problem with AXRCMD returning not all the lines of a JES2 display
command.
A system rexx is coded as follows:
rc = axrcmd('$DPROCLIB','proclib.',5)
if rc <> 0 then do
say 'axrcmd $DPROCLIB returned non-zero return code:' rc
return(rc)
end
say '---------START-'rc'--'proclib.0'-------------------------------'
do i = 1 to proclib.0
say '---'i'---'proclib.i
end
say '---------------------END-------------------------------'
This results in the following 8 lines written to SYSLOG:
---------START-0--8-------------------------------
---1--- $HASP319 PROCLIB(PROC00)
---2--- $HASP319 PROCLIB(PROC00) DD(1)=(DSNAME=SYSL.TMP.PROCLIB.PL+
EX9
---3--- $HASP319 1.IP91B1),
---4--- $HASP319 DD(2)=(DSNAME=SYSN.EOC.PROCLIB),
---5--- $HASP319 DD(3)=(DSNAME=SYSL.MID.PROCLIB.PL+
EX9
---6--- $HASP319 1),
---7--- $HASP319 DD(4)=(DSNAME=SYSN.MID.PROCLIB),
---8--- $HASP319 DD(5)=(DSNAME=SYS1.IBM.PROCLIB)
---------------------END-------------------------------
However in SDSF, /$DPROCLIB results in 12 lines:
$HASP319 PROCLIB(PROC00)
$HASP319 PROCLIB(PROC00) DD(1)=(DSNAME=SYSL.TMP.PROCLIB.PLEX9
$HASP319 1.IP91B1),
$HASP319 DD(2)=(DSNAME=SYSN.EOC.PROCLIB),
$HASP319 DD(3)=(DSNAME=SYSL.MID.PROCLIB.PLEX9
$HASP319 1),
$HASP319 DD(4)=(DSNAME=SYSN.MID.PROCLIB),
$HASP319 DD(5)=(DSNAME=SYS1.IBM.PROCLIB)
$HASP319 PROCLIB(PROC01)
$HASP319 PROCLIB(PROC01) DD(1)=(DSNAME=SYSL.TMP.PROCLIB.PLEX9
$HASP319 1.IP91B1),
$HASP319 DD(2)=(DSNAME=SYSN.TSO.PROCLIB)
Anybody an idea or should I APAR it?
Any help would be greatly appreciated.
Best regards,
j@n
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
