>> If that requires the resolution of JCL procedures or JCL INCLUDEs, the >> only source for this is the "procedure library" of the subsystem. > > So you are saying that JCLLIB is never accepted in a started PROC?
No, I didn't mean to imply that. I just leaft out JCLLIB inadvertently. This statement should read: If that requires the resolution of JCL procedures or JCL INCLUDEs, the only source for this is the "procedure library" of the subsystem, and any JCLLIB library which may be present in the JCL *if* the JCL was the result of step 1a) or 2a). I changed this also in the text below. -- Peter Hunkeler -----Original Message----- From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf Of Peter Hunkeler Sent: Saturday, December 20, 2014 12:51 PM To: [email protected] Subject: AW: Re: JCLLIB in started proc? The START command processor needs to build and "initiate" some JCL to start what was requested. The JCL will be sent to a subsystem that is able to process that JCL. The Master Subsystem (MSTR) and the Job Entry Subsystems 2 (JES2) and 3 (JES3) are the ones I know. The first operand of the START command is shown as "membername" in the System Command reference. For brevity, I name it "MEMBER" hereafter. In order to build the JCL, the START command processor performs the following steps: 1) Search for MEMBER in the data sets allocated under IEFJOBS in the master scheduler JCL. If found, this member *must* contain a job, i.e. it must start with a JOB statement. 1a) If it does, this JCL is used in step 4) below. Continue with step 4). 1b) If it does not, an error is returned and processing ends. 2) Search for MEMBER in the data sets allocated under IEFPDSI in the master scheduler JCL. 2a) If found and if the member contains a job, i.e. it starts with a JOB statement, this JCL is used in step 4) below. Continue with step 4). 2b) If found but the member does *not* start with a JOB statement, it is ignored. Continue with step 3). 3) Build a job to invoke MEMBER as JCL procedure, i.e. build a JOB statement and an EXEC PROC=MEMBER statement. Continue with step 4). 4) Send the JCL found or built in steps 1) - 3) to the subsystem for processing. The subsystem is the primary JES by default, or the one named on SUB=, if specified. Exception: If MEMBER is the name of a subsystem (IEFSSNxx), then the default subsystem is MSTR. 5) START command processing ends. After this point, the *subsystem* has to process the JCL. If that requires the resolution of JCL procedures or JCL INCLUDEs, the only source for this is the "procedure library" of the subsystem, and any JCLLIB library which may be present in the JCL *if* the JCL was the result of step 1a) or 2a). - If the subsystem is the Master Subsystem, then the only "procedure library" is the set of data sets allocated under IEFPDSI in the master scheduler JCL. - If the subsystem is one of the JESs, then the only "procedure library" is the set of data sets allocated under the PROCnn (nn is the set assigned to STC jobclass in JES). ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
